Do it yourself
Frequently asked questions about cars and motorcycles

How to top up the coolant on a BMW 3 Series?

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Checks and maintenance

To top up the coolant on a BMW 3 Series, follow these steps. Make sure the engine is cool before proceeding. Open the hood and locate the coolant reservoir, usually transparent and located near the engine. Check the coolant level, which should be between the minimum and maximum lines on the reservoir. If the level is low, carefully remove the reservoir cap. Use a clean funnel to add specific BMW coolant, mixed with distilled water in the correct ratio, until it reaches the maximum line. Make sure the reservoir cap is tightly closed to avoid leaks. After adding the coolant, start the engine and let it run for a few minutes to allow the coolant to circulate through the system. Check the coolant level again and add more if necessary to reach the maximum line. Close the hood and make sure it is securely closed. Check the coolant level periodically and top up if necessary to keep your BMW 3 Series engine in excellent condition.

Posted on 3 May 2024 by ScegliAuto

Video tutorial

Related tutorials

BMW Serie 3 (2005-2013 / E91, E90, E92) Want to check and top off the coolant reservoir? Here's how to add coolant to your BMW 3 Series. Pull the plastic lever located at the bottom left of…
BMW Serie 3 (2012-2019 / F30, F31) In this tutorial, we can see how to check and top up the coolant in the BMW 3 Series, a very simple and quick operation. First of all, make sure that…
BMW Serie 3 (1990-2001 / E36) Below are the instructions to remove and replace the cabin heater radiator in a BMW 3 Series. First, open the hood of your car and start disconnectin…

    Frequently Asked Questions

    • Serie 3 2012-2019 - How much does a service cost for the BMW 3 Series? Read answer
    • Serie 3 2005-2013 - Why is the on-board computer of the BMW 3 Series slow to start up? Read answer

How to Open the Bonnet of a Renault Megane if the Lever is Broken?

If the lever that unlocks the bonnet of the Renault Megane is broken or not functioning, there is an emergency procedure to unlock the mechanism: remove the right front grille located at the top of the bumper. Once the grille is removed, you can locate the actuator mechanism: by pulling the spring in this position, you can unlock the actuator, allowing you to lift the bonnet and access the components located inside the engine compartment. You can then close the bonnet simply by lowering it.

Watch the video!


by ScegliAuto

More videos