Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Chevrolet
    3. :
  3. Spark
    4. : Replacement oil and oil filter on Chevrolet Spark

Chevrolet Spark - Video tutorial

Model: Chevrolet Spark - Years 2009-2018
Part: Oil filter
Operation: Replacement oil and oil filter on Chevrolet Spark

Raise the car with a jack (if you don't have the bridge). Using a 15 mm socket wrench, unscrew the drain bolt located under the engine compartment, as shown in the video. Collect the used oil in a container, perhaps with the help of a funnel or a pipe. Near the drainage hole you can see the special oil filter: to replace it, simply unscrew it, then insert and screw the new filter. Be careful because even when you take the old filter apart, some oil will leak. Lower the car and open the hood: load the new lubricant from the compartment on your left (facing the passenger compartment).


Posted on 6 January 2024 by ScegliAuto



How do you change the oil on a Chevrolet Spark?
Chevrolet Spark (2016-2022 / M400) Before doing anything, we raise the front hood hatch and unscrew the engine oil filler cap. We then proceed to lift the car onto a bridge or jack sta
How to reset oil change on Chevrolet Spark
Chevrolet Spark (2009-2016 / M300, MK 1) In this video tutorial we can see how to reset the oil light on Chevrolet Spark, following simple steps. When the change oil warning light comes on a
How to replace the spark plugs on a Chevrolet Spark
Chevrolet Spark (2009-2016 / M300, MK 1) Let's start by opening the bonnet of our Chevrolet Spark. Next we will have to disassemble and remove the air filter box, unscrewing the fixing screw

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos