Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Wheel Bearing on a Chevrolet Aveo

Model: Chevrolet Aveo MK 1, T200 - Years 2002-2011
Part: Bearing

The first step is to remove the wheel that requires the bearing replacement, as the bearing is located inside the wheel hub. After removing the wheel, proceed to remove the brake pads and the disc. For these replacements, you can refer to our guides on the website. Once completed, compare the new bearing with the one already installed. Once you confirm they are the same part, you can proceed to unscrew the large central bolt, allowing you to extract the old bearing and install the new one.

Updated on 24 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Wheel Bearing on a Chevrolet Aveo?
How to Replace the Front Wheel Bearing on a Chevrolet Aveo?
Chevrolet Aveo (2002-2011 / MK 1, T200) To replace the front wheel bearing on a Chevrolet Aveo, lift the car with a jack so that the corresponding front wheel can be removed from its housin…
How to Replace the Front Hub Bearing on a Chevrolet Aveo?
How to Replace the Front Hub Bearing on a Chevrolet Aveo?
Chevrolet Aveo (2002-2011 / MK 1, T200) In this tutorial, you will see how to replace the front hub bearing on a Chevrolet Aveo, a straightforward operation but one that requires good manua…
How to Remove the Rear Bumper of the Chevrolet Aveo?
How to Remove the Rear Bumper of the Chevrolet Aveo?
Chevrolet Aveo (2002-2011 / MK 1, T200) To remove the rear bumper of the Chevrolet Aveo, open the boot and loosen the screws located just below the seal and next to the rear lights. Next, l…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos