Do it yourself
Frequently asked questions about cars and motorcycles

Resolution of the pedal sensor problem on a Citroen C3 1.4 H

Model: Citroen C3 SY, SX - Years 2016-2023
Part: Accelerator

In this video we can see how to solve the problem of a throttle pedal sensor of a Citroen C3 1.4 DHi which is manifested by the error light coming on; the engine then went into protection mode for several starts, and a diagnosis showed error code P2137, so it was necessary to order a new pedal, which can be found for example on carsystemfp.com with code 0280755084 at the price of 25.00 euros. We will remove the three plastic rivets on the partition above the pedal, which will then come off easily. We need a 10 mm torx key, which we will use to remove the two nuts holding the pedal: from the slot under the steering wheel we locate the gray plug, pull up the orange part, and lift the gray tab. Once the pedal is removed, we need to identify the three pins, reattach them and then reconnect the electrical connectors that we had previously removed. Now with our OBD2 reader we check, but the error is still there, in fact error code P2137 has been added as well. However, after a few starts, the codes have self-cleared; probably the new part was recognized, or after multiple starts the lights clear themselves.

Posted on 6 December 2024 by ScegliAuto

Video tutorial

Related tutorials

Citroen C3 (2009-2016 / SC) In this video, we see that a Citroen C3 is struggling at idle and running poorly when cold. The problem has been identified as the Manifold Absolute …
Citroen C3 (2002-2009 / FC, FN) Before you start, open the front bonnet of your Citroen C3. The sensor is located near the left side of the cylinder head. This procedure should be c…
Citroen C3 (2002-2009 / FC, FN) In this short and simple guide, you will find the necessary instructions to remove and replace the coolant temperature sensor on the Citroen C3 1.4i.…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos