Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installing Underbody Strobe Lights

Model: Citroen Saxo MK 1 - Years 1996-2004
Part: Accessory kit

First, lift the vehicle using a lift or suitable axle stands to facilitate the installation process.
It is recommended to install the strobe light under the lower crossmember of the grille (just below the radiator), avoiding contact with hot and moving parts.
Once you have identified the installation position, secure the strobe light with cable ties, ensuring it remains perfectly horizontal.
At this point, route the power wires of the strobe light to the fuse box in the engine bay (where you can connect the positive and negative) and from there run two more wires into the cabin to install the switch.

Updated on 4 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Intake Manifold Gasket
Replacing the Intake Manifold Gasket
Citroen Saxo (1996-2004 / MK 1) The intake manifold gaskets are four rings that must be properly seated in their respective grooves corresponding to the intake ducts; once the new g…
Guide to Replacing the Handbrake
Guide to Replacing the Handbrake
Citroen Saxo (1996-2004 / MK 1) This guide provides precise instructions on how to repair the handbrake of your car without needing to consult an expert mechanic or spend a fortune.…
Replacement of Camshaft Oil Seal
Replacement of Camshaft Oil Seal
Citroen Saxo (1996-2004 / MK 1) Before inserting the new oil seals into the respective seats of the camshafts, ensure there are no dirt residues, lubricate both the seat and the oil…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos