Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Rocker Cover Gasket Replacement

Model: Citroen C1 MK 1 - Years 2005-2014
Part: Engine

After thoroughly cleaning the gasket seating on both the cylinder head and under the rocker cover, insert the new gasket into the corresponding seating just below the rocker cover, ensuring it adheres correctly along the entire edge; in this case, there is no need to apply gasket sealant. Then position the cover on the cylinder head and secure the three fastening pins using new washers and a torque wrench to tighten them. Start the engine and bring it to operating temperature, ensuring there are no oil leaks from under the cover.

Updated on 12 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Radiator on a Citroen C1
Citroen C1 (2014-2022 / MK 2) Lift the car to access the area beneath the radiator. Disconnect the flexible hose leading to the heat exchanger by removing its clip, and allow the …
How to Replace the Clutch on a Citroen C1?
How to Replace the Clutch on a Citroen C1?
Citroen C1 (2005-2014 / MK 1) Replacing the clutch on a vehicle is quite complex. Here’s a brief summary of the steps: First, lift the car, drain the oil, and remove the two front…
How to Replace the Front Headlamp Bulbs on a Peugeot Citroen C1
How to Replace the Front Headlamp Bulbs on a Peugeot Citroen C1
Citroen C1 (2005-2014 / MK 1) Learn how to replace the bulbs in the front headlamp on a Peugeot Citroen C1. Open the bonnet by pulling the lever located at the bottom right of the…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos