Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Windscreen Washer Reservoir on a Fiat Bravo

Model: Fiat Bravo Bravo 2 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014
Part: Windshield wipers

See other generations:
This video is currently unavailable

As shown in the video, remove the wheel by raising the car with a jack and unscrewing the relevant bolts. Unscrew the screws of the wheel arch liner and remove it as well.

At this point, unscrew the screws of the bumper and above the bumper, then detach it from the rest of the bodywork. Unscrew the three screws of the headlamp and also detach the light unit.

At this point (you will finally say), you will have free access to the windscreen washer reservoir. As you can see, it is secured with three screws.

Once unscrewed and removed, you can replace the reservoir in question. Reassemble everything by reversing the steps.

Good luck!


Updated on 23 April 2026 by ScegliAuto


Related tutorials

How to Replace the Wiper Blades on a Fiat Bravo 2
How to Replace the Wiper Blades on a Fiat Bravo 2
Fiat Bravo (2007-2014 / Bravo 2) In this tutorial, you will learn how to replace the wiper blades on a Fiat Bravo 2 by following a few simple steps: first, purchase new wiper blades …
How to Replace the Engine Oil and Filter on the Fiat Bravo 2
How to Replace the Engine Oil and Filter on the Fiat Bravo 2
Fiat Bravo (2007-2014 / Bravo 2) When the oil warning light comes on in a Fiat Bravo, you need to replace the oil and the corresponding filter. Open the front bonnet and the oil fill…
How to Replace the Fuel Cap Strap on a Fiat Bravo?
How to Replace the Fuel Cap Strap on a Fiat Bravo?
Fiat Bravo (2007-2014 / Bravo 2) To replace the fuel cap strap on the Fiat Bravo, first use a flat screwdriver to lift the tab on the flap and extract the strap. By removing the cap …

How to open the boot if it is stuck on a Mercedes B-Class?

On the Mercedes B-Class, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In this case, perform the emergency opening by following the simple procedure shown in this tutorial. First, unlock the locks with the remote control, then open the rear doors and, by operating the indicated lever, lower the backrest of the seat. Next, go inside the boot, locate the indicated gap, and manually unlock the lock using a small screwdriver.

Watch the video!


by ScegliAuto

More videos