Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Engine from a Fiat 126?

Model: Fiat 126 MK 1 - Years 1972-1991
Part: Engine

In this guide, you will see the main steps on how to disassemble and remove the entire engine block from a Fiat 126, as well as from a classic Fiat 500. First, open the bonnet and start by removing the rear bumper; then disconnect the electrical wires from the coil and the alternator, as shown in the video. Next, remove the fuel pipes from the filter to the carburettors; then disconnect the air filter. Now move to the transmission area, removing the bolts from the drive shaft; also disconnect the exhaust system. Lift the engine to remove it, following the video until the end!

Updated on 28 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil of the Fiat 126
How to Change the Engine Oil of the Fiat 126
Fiat 126 (1972-1991 / MK 1) Briefly change the engine oil on the Fiat 126 by following the instructions below. First, raise the vehicle and remove the oil drain bolt located on …
Engine Oil Change for the Fiat 126
Engine Oil Change for the Fiat 126
Fiat 126 (1972-1991 / MK 1) In this video, see how to change the engine oil of the Fiat 126, as well as the classic 500. First, lift the vehicle and start by removing the rear b…
How to Dismantle the Engine of the Fiat 126
How to Dismantle the Engine of the Fiat 126
Fiat 126 (1972-1991 / MK 1) In this video, see how to dismantle the 650cc engine of the Fiat 126. Dismantling this engine is extremely simple compared to modern vehicles, as it …

Other guides you may be interested in

How to reset the tyre pressure warning light on the Suzuki Jimny?

To reset the tyre pressure warning light on the Suzuki Jimny, first inflate the tyres to the pressure value indicated on the corresponding sticker: this is located at the bottom of the driver's door pillar. Once the tyres are inflated, insert the ignition key and turn on the instrument panel: select the screen that indicates the tyre pressures, checking that the values change. After a few seconds, the tyre pressure warning light will automatically turn off.

Watch the video!


by ScegliAuto

More videos