Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Panda
    4. : How to replace the Fiat Panda fog light bulbs

Fiat Panda - Video tutorial

Model: Fiat Panda MK 2, 169 - Years 2003-2012
Part: Fog lights
Operation: How to replace the Fiat Panda fog light bulbs

As a first operation, disconnect the plugs from the battery to protect the various electronic components of your car, then you can now go and operate on the fog light, just unscrew the screws and bolts that secure the grille where the fog light is positioned to be able to remove it and then extract the protective cap on the back, now you just have to disconnect the plug on the back and go and extract the lamp holder. Now you can remove the used bulb and install the new bulb and that's it! Go back through the steps to reassemble the various components.


Posted on 25 September 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Panda 2003-2012 - Where are the fog lights located in the Fiat Panda? Read Answer
    • Panda 2003-2012 - How do you replace the fog lights on the Fiat Panda? Read Answer
    • Panda 2012-2023 - How much do the fog lights (assembly included) cost on a 2020 Fiat Panda Easy? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos