Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Refill drain conditioner

Model: Ford Mondeo / Fusion MK 2 - Years 2000-2007
Part: Air conditioning

After a few years of use, the air conditioner can run out, that is, the gas inside the content due to some leaks can disperse and therefore the air conditioner loses its effectiveness. To remedy this, it is necessary to recharge the system. Obtain the appropriate gas canister equipped with a dispenser and pressure regulator. Start the engine and bring the air conditioner temperature to minimum. Unscrew the screws of the front right wheel mudguard in order to easily access the refill valve on the rear. Connect the regulator to the valve then shake the bottle to mix the gas and then connect it to the regulator. Press the special lever on the regulator to release the gas and constantly check the pressure which must not exceed the green zone. When you reach the right pressure, disconnect the dispenser, close the valve and check that the air conditioner is working perfectly.


Posted on 5 July 2023 by ScegliAuto



Change gear oil on Ford Mondeo 1 8 tdci
Ford Mondeo / Fusion (2000-2007 / MK 2) To change the gear oil it is necessary to proceed as follows: remove the air filter, the battery and the battery support. Locate the oil filler cap a
How do you replace the accessory belt on the Ford Mondeo 2?
Ford Mondeo / Fusion (2000-2007 / MK 2) The service belt plays a very important role in the car, especially because it is used to recharge the power battery of the same car. Follow the vide
2009 Ford Mondeo cabin filter replacement
Ford Mondeo / Fusion (2007-2014 / MK 3) When operating the air conditioner you feel a bad smell coming from the ventilation vents, it means that the passenger compartment air filter is clog

Other guides that may interest you

How to remove the telepass holder from the windshield

Today we will explain how to remove the telepass holder from a vehicle's windshield. Removing the telepass holder from the windshield is a very simple and quick operation to perform independently, you just need to use nylon thread that you will need to pull towards the holder and pass it between the holder and the clip. After performing this operation, the holder will be removed. There may be glue residues on the windshield that can be removed with a solvent suitable for glass cleaning. After cleaning everything, it is possible to mount another telepass holder on the windshield in the same position as the one removed or elsewhere.

Watch the video!


by ScegliAuto

More videos