Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : How to reset the engine fault in a Ford Focus

Ford Focus - Video tutorial

Model: Ford Focus MK 3 - Years 2011-2018
Part: -board computer
Operation: How to reset the engine fault in a Ford Focus

In this video we will see how to reset the engine failure light of a Ford Focus. The model in question does not have the steering wheel controls, so position yourself in the driving position and just switch on the ignition. Observe the writing "Engine Malfunction" on the odometer display, now press the brake and accelerator pedals at the same time for about 20 seconds. Now release the pressure pedals and turn off the ignition. The next time the car is restarted, the warning light with the wording of engine malfunction (Engine) should have disappeared completely, in case repeat the procedure.


Posted on 10 September 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Focus 2018-2025 - Why is the display of the Ford Focus not working anymore? Read Answer
    • Focus 1998-2004 - How to access the hidden menu of the Focus? Read Answer
    • Focus 2011-2018 - Why doesn't the Ford Focus screen turn off? Read Answer
    • Focus 2011-2018 - What does the Ford Focus engine light indicate? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos