Replacing Car Brake Discs

Model: Ford Focus MK 1 - Years 1998-2004
Part: Brake rotors

Safety in a car is one of the essential conditions of a good braking system. With a few simple steps, you can change the car's brake discs yourself. The brake discs must have a minimum thickness, indicated in the car's manual. Therefore, it is good practice to periodically check that it has not been exceeded. If at least one is below the prescribed minimum, the discs must be replaced. Many car manufacturers recommend replacing the discs around 50,000 miles, and it is advisable to change the pads at the same time. First, turn the steering wheel to your side so that the brake caliper faces you. Lift the car with a jack and remove the wheel after taking off the wheel bolts. Use an Allen key to unscrew all the bolts that secure the caliper to the frame on the rear side. Then, you can slide off the brake caliper. At this point, only the caliper bracket with the brake pads inside will remain. Remove the pads using an appropriate flat screwdriver, taking care not to damage the disc. Next, unscrew the bolts that secure the bracket to the hub. This will leave only the brake disc, which will need to be replaced.

Updated on 14 February 2026 by ScegliAuto

This video is currently unavailable

Other guides you may be interested in

- Maintenance and repair on other vehicles

Brake Pads - Maintenance and repair on other vehicles

Wheel - Maintenance and repair on other vehicles

- Maintenance and repair on other vehicles

Steering Wheel - Maintenance and repair on other vehicles

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!

by ScegliAuto

Replacing Car Brake Discs

Related tutorials

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

More videos