Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : How to replace the front brake pads on the Ford Focus MK1.

Ford Focus - Video tutorial

Model: Ford Focus MK 1 - Years 1998-2004
Part: Brake pads
Operation: How to replace the front brake pads on the Ford Focus MK1.

In this video, we see how to replace the brake pads on a Ford Focus MK1. First, we open the hood and remove the cap from the brake fluid reservoir. Then, we unscrew the bolts from the front wheels and lift the car, securing it with jack stands (we shouldn't rely too much on our jack). Next, we remove the front wheels. We clean the brake calipers thoroughly, even using WD-40 if necessary. Then, we remove the upper and lower bolts and move the caliper. We remove the brake pads and take out the piston. Next, we install the new pads, applying copper grease to the ends to prevent squeaking. We clean the disc with a suitable product and then proceed to re-install the caliper: we close the springs, tighten the bolts, and spray copper grease in the central part. We can put the wheels back on and lower the car. We close the brake fluid cap. Finally, we press the brake pedal a few times to circulate the fluid. The operation is complete.


Posted on 17 January 2024 by ScegliAuto

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos