Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Oil Pressure Sensor in the Ford C-MAX?

Model: Ford C Max MK 2 - Years 2010-2019
Part: Checks and maintenance

Replacing the oil pressure sensor in the Ford C-MAX, as shown in this tutorial, is a very simple and quick task. Before proceeding, ensure the engine is completely cold for safety. Start by raising the front of the vehicle, then go underneath and locate the sensor near the oil filter. Disconnect the power connector, unscrew the sensor using a spanner, and fit the replacement by following the reverse procedure. A small amount of oil will be lost during the operation, so be prepared to top it up.

Updated on 28 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Where is the External Temperature Sensor on a Ford C-Max?
Where is the External Temperature Sensor on a Ford C-Max?
Ford C Max (2010-2019 / MK 2) The external temperature sensor on a Ford C-Max is located inside the external rear-view mirror on the passenger side. The sensor can be found at the…
How to reset the tire pressure sensor on a Ford C-MAX
How to reset the tire pressure sensor on a Ford C-MAX
Ford C Max (2010-2019 / MK 2) Today we can see how to reset the tire pressure sensors on a second generation Ford C-MAX. To perform this procedure we will need a specific reset to…
How to Remove the Oil Light in the Ford C-MAX Hybrid?
How to Remove the Oil Light in the Ford C-MAX Hybrid?
Ford C Max (2010-2019 / MK 2) In this tutorial, you will see how to reset the engine oil light in the Ford C-MAX Hybrid, a very simple and quick operation that should only be done…

Other guides you may be interested in

    Frequently Asked Questions

    • C Max 2010-2019 - Why is the tire sensor not detected on the Ford C Max? Read answer

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos