Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the TPMS on Ford Vehicles with Start Button

Model: Ford Ford Various
Part: Tire pressure warning light

In this video, you will learn how to re-learn the TPMS on Ford vehicles that have a start button. This is necessary if you change one or more sensors in the wheels, or if you switch between summer and winter tyres. Inflate the tyres slightly above the required pressure and follow this procedure. You will only need a small screwdriver or a pen. Start the vehicle with the button and press the hazard light button three times. The vehicle will respond with a horn beep, and if you look at the display, you will see the message "left front wheel". Go to this wheel and release the excess air using your small screwdriver from the valve. When you reach the correct pressure, the vehicle will alert you with a horn beep. Now proceed clockwise to all the other wheels and follow the same method. In the end, you will see that the TPMS light has turned off.

Updated on 1 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to reset the battery management system on Ford vehicles
How to reset the battery management system on Ford vehicles
Ford Ford Various In this video, see how to reset the Battery Management System (BMS) on a Ford C-Max, but the system is applicable to all Ford vehicles. Each time you…
How to Reset the START&STOP System on a Ford
Ford Ford Various Resetting the START&STOP system on Ford models is more or less the same for all new generation models. The reset process is very simple; just hold do…
How to reset the service light on Ford vehicles
How to reset the service light on Ford vehicles
Ford Ford Various Resetting the tire pressure warning light on a Ford vehicle is a fairly simple and quick operation that can be done independently. To perform this op…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos