Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of Aftermarket Xenon Headlight Kit

Model: Honda Civic MK 6 - Years: 1995, 1996, 1997, 1998, 1999, 2000, 2001
Part: Xenon headlight kit

See other generations:
Video tutorial

First, check the compatibility of the Xenon kit with the vehicle, ensure all components are present (two bulbs, two control units, and the wiring harness), and read the installation instructions carefully. The first step is to connect the power supply of the wiring harness directly to the battery terminals, ensuring correct polarity, and position the relay appropriately.

Next, securely mount the control units near the two headlights (it is recommended to place them inside the edge of the wheel arches) and position the wiring to avoid interference with moving parts (fans, pulleys) or hot areas of the engine. Then, replace the original bulbs with those included in the kit, ensuring they are properly secured in the headlight reflector and connect the respective plugs to the control unit (these are mandatory male-female connections).

Finally, connect the eyelet of the ground cable to the vehicle chassis (use an existing ground point - body fixing bolt - or drill a hole in the bodywork). Then, perform a functionality check and adjust the beam orientation if necessary.


Updated on 3 February 2026 by ScegliAuto


Related tutorials

Installation of Aftermarket Xenon Headlight Kit
Installation of Aftermarket Xenon Headlight Kit
Honda Civic (1992-1995 / MK 5) Open the bonnet and disconnect the negative terminal of the battery to isolate it. Unclip and remove the air intake duct to gain easier access to the…
Installation of Aftermarket Xenon Headlight Kit
Installation of Aftermarket Xenon Headlight Kit
Honda Civic (1995-2001 / MK 6) Open the front bonnet and remove the protective cap from the headlight bulb holder; then disconnect the H4 bulb plug to be replaced with that of the …
Installation of Shaped Rubber Floor Mats
Installation of Shaped Rubber Floor Mats
Honda Civic (2006-2012 / MK 8) Installing shaped rubber floor mats for the specific car model with raised edges is extremely simple; just place them over the original carpet mats a…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos