Do it yourself
Frequently asked questions about cars and motorcycles

Engine Oil and Oil Filter Replacement for Honda CR-V

Model: Honda CR-V MK 5 - Years 2017-2022
Part: Engine oil

Open the bonnet and secure it with the support rod. Unscrew the engine oil filler cap. Position the jack and lift the car, then remove the soundproofing panels under the engine by unscrewing the relevant fixing screws. Locate the oil drain plug and, using a 17 mm spanner, loosen the nut while placing an oil collection tray underneath. Finish unscrewing the nut and wait for all the oil to drain out. Also locate the oil filter and, using an appropriate tool, remove the filter by hand, waiting for any remaining oil to drain out. After that, refit the 17 mm nut and install the new filter, having lubricated the seal with new oil. Tighten the filter by hand, without using tools. Take a funnel and position it on the filler neck, then begin to fill with suitable oil. Wait a few minutes for the oil to settle completely and check the oil level with the dipstick, ensuring it is above the minimum mark. Close the oil filler cap, then start the engine and let it run for a few seconds before turning it off. Top up the oil, checking with the dipstick that the level is between minimum and maximum. Finally, close the bonnet.

Updated on 12 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Honda CR-V (2007-2012 / MK 3) Today, this short video will show you how to change the engine oil and oil filter on your Honda CR-V. It is not a very complex operation; just take s…
Honda CR-V (2007-2012 / MK 3) As you know, no matter how new a car is, over time and mileage, small issues can arise that are easily fixable and fortunately inexpensive. In this v…
Honda CR-V (2012-2017 / MK 4) How to replace the oil filter on a Honda CR-V? When replacing the filter, it is better to also replace the oil. Lift the car on a jack and unscrew th…

Other guides you may be interested in

How to Open the Bonnet on the Lancia Y

To open the bonnet on this vehicle, follow these simple instructions: first, open the driver's door and locate the lever positioned just below the dashboard, marked with an image of the vehicle with the bonnet open. Pull this lever towards you until you hear a "click" indicating the bonnet is released. Next, exit the cabin and stand in front of the bonnet to disengage the safety catch and complete the opening. To do this, slightly lift the bonnet, locate the yellow lever underneath, and pull it to the left to fully release and open the bonnet.

Watch the video!


by ScegliAuto

More videos