Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Husaberg Fe 350 - Videoguide

Husaberg Fe 350
How do you replace the exhaust pipe of the Husaberg FE 350?
The operation of replacing the exhaust on the Husaberg FE 350 involves loosening the screws that secure the side protection panel of the rear fender, on the …read all…
Posted on 26 February 2024 by ScegliAuto
Husaberg Fe 350
How do you replace the crankshaft seal on the Husaberg FE 350?
In order to replace the crankshaft seal of the Husaberg FE 350, you need to loosen the central nut that secures the sprocket, located on the left side of the …read all…
Posted on 21 November 2023 by ScegliAuto
Husaberg Fe 350
How do you replace the fuel pump on the Husaberg FE 350?
To replace the fuel pump on the Husaberg FE 350 you need to loosen the screws that fix the saddle to its housing and the screws positioned in the front side …read all…
Posted on 6 May 2023 by ScegliAuto
Husaberg Fe 350
How to change the Husaberg FE 350 engine oil
Let's see in this guide how to carry out the routine maintenance service, replacing the engine oil and the oil filter, of the Husaberg FE 350 enduro bike. …read all…
Posted on 18 August 2022 by ScegliAuto
Husaberg Fe 350
How do I replace the air filter on Husaberg FE 350?
In order to replace the air filter on the Husaberg FE 350 you have to remove the left side panel of the bike, which is positioned immediately under the saddle. …read all…
Posted on 2 April 2024 by ScegliAuto
Husaberg Fe 350
How do you remove the rear shock absorber from Husaberg FE 350?
In order to remove the rear shock absorber of the Husaberg FE 350 you need to use a socket wrench to loosen the bolt located on the right side of the bike. …read all…
Posted on 16 March 2024 by ScegliAuto
Husaberg Fe 350
Replace the water pump oil seal on the Husqvarna FE 350
Let's see in this video how to disassemble and replace the oil seal of the water pump on a Husqvarna FE 350 enduro motorcycle, following the instructions …read all…
Posted on 13 February 2024 by ScegliAuto
Husaberg Fe 350
Removing the chain and sprocket on Husaberg FE 350
In this video tutorial we will see the instructions to be able to disassemble the chain and the rear sprocket of a Husaberg FE 350, following these …read all…
Posted on 4 January 2024 by ScegliAuto
Shock absorbers (1) (1) Checks and maintenance (1) Air filter (1) Muffler (1) Engine oil (1) Fuel pump (1)

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos