Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. Santa Fe
    4. : Replacement of rear brake pads

Hyundai Santa Fe - Video tutorial

Model: Hyundai Santa Fe MK 1 - Years 2000-2006
Part: Brake pads
Operation: Replacement of rear brake pads

Raise the car on a lift and remove the rear wheel; then disassemble the fixing pins of the brake calliper and remove it from the support; remove the old pads; lubricate the caliper fixing pins; remove the pad retaining springs from the holder and clean them if there are no new ones in the kit. Then apply the nine tablets; return the cylinder to the calliper using an arc clamp and install it on the relative support by carefully tightening the fixing pins. Proceed in the same way on the other wheel. Pay attention to the first braking.


Posted on 23 July 2023 by ScegliAuto



Replacing the brake pads on a Hyundai Santa Fe
Hyundai Santa Fe (2000-2006 / MK 1) Replacing the front brake pads? We see the teardown on a Hyundai Santa Fe. We lift the car on a column bridge to the desired height, remove the wheel
Replacement of front brake pads
Hyundai Santa Fe (2000-2006 / MK 1) Raising the car to replace the brake pads will make the operation much easier and more comfortable to perform; once raised, remove the front wheel an
Replacement of front brake pads
Hyundai Santa Fe (2006-2012 / MK 2) Loosen the wheel nuts and lift the car to secure it. Unscrew the bolts and remove the wheel. With the help of a screwdriver and hammer push out the t

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos