Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Fit the Spare Wheel on a Jeep Wrangler

Model: Jeep Wrangler MK 3, JK - Years 2007-2018
Part: Wheel

The steps to correctly fit the spare wheel in an emergency are quite simple and take only a few minutes to complete. First, open the rear tailgate, lift the plastic cover, and access the repair kit provided by Jeep in all its vehicles. Close the tailgate and unscrew all the screws holding the spare wheel in place using the appropriate key. Pull it towards you and place it on the ground next to the wheel to be replaced. Now, lift the vehicle with a suitable jack and unscrew the bolts of the wheel rim to be removed. Remove the wheel and replace it with the spare. Finally, reattach all the screws and lower the vehicle.

Updated on 6 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Removing the Centre Brake Light on Jeep Wrangler
Removing the Centre Brake Light on Jeep Wrangler
Jeep Wrangler (2018-2026 / JL, MK 4) How to remove the third brake light on a Jeep Wrangler? The light is located above the spare wheel of the vehicle. Remove the spare wheel, then unscr…
How to Remove the Spare Wheel from the Jeep Wrangler
How to Remove the Spare Wheel from the Jeep Wrangler
Jeep Wrangler (2018-2026 / JL, MK 4) If you need to use the spare wheel on the vehicle or simply want to remove it, just follow these steps. Before you start, ensure that the car's engin…
How to Replace the Starter Motor on a Jeep Wrangler
How to Replace the Starter Motor on a Jeep Wrangler
Jeep Wrangler (2007-2018 / MK 3, JK) To replace the starter motor on a Jeep Wrangler, access it from inside the wheel arch of the front right wheel. First, open the bonnet and disconnect…

Other guides you may be interested in

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos