Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Jeep
    3. :
  3. Compass
    4. : How do you replace the headlight bulb on the Jeep Compass?

Jeep Compass - Video tutorial

Model: Jeep Compass 552, MK 2 - Years 2016-2024
Part: Headlight bulb
Operation: How do you replace the headlight bulb on the Jeep Compass?

Replacing the headlight bulb on the Jeep Compass is done by opening the bonnet, so that you have access to the components located inside the engine compartment: in the case of the right headlight, it will be necessary to completely remove the air filter box to access the inside of the lighthouse. Once the box has been removed, it will be necessary to remove the circular protective cover inside the headlight, so that the bulb can then be extracted from its seat and disconnected from the relative connector. This will allow you to connect and install the new bulb, closing the bulb and installing the air filter box.


Posted on 11 April 2023 by ScegliAuto



How to replace the headlight bulb on a Jeep Compass
Jeep Compass (2006-2016 / MK 49, MK 1) Before we can begin, we will have to go and open the front hood of our Jeep Compass. So let's start by disconnecting the electrical connector connect
How do you replace the front headlight bulb of the Jeep Compass?
Jeep Compass (2016-2024 / 552, MK 2) The operation of replacing the headlight bulb on the Jeep Compass is done by loosening the screws that secure the inner cover of the fender in corres
Jeep Compass headlight bulb replacement
Jeep Compass (2016-2024 / 552, MK 2) Today we will see how to remove and replace the headlight bulb of a Jeep Compass. First of all, let's remove the mudguard screws from the affected si

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos