Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Land Rover
    3. :
  3. Freelander
    4. : Where is the fuel filter located in the Land Rover Freelander?

Land Rover Freelander - Video tutorial

Model: Land Rover Freelander Freelander 2 - Years 2006-2016
Part: Diesel filter
Operation: Where is the fuel filter located in the Land Rover Freelander?

In this video, we can see where the fuel filter is located in the Land Rover Freelander 2, useful in case we need to clean or replace it directly. As shown, it is located inside the engine compartment, precisely in the front right area, right next to the windshield washer fluid reservoir. In case we need to remove it, it will be sufficient to disconnect the upper power connector, the two fuel pipes, and unscrew the fixing bolts of the support bracket. Once removed, disconnect the water sensor and install the replacement following the reverse procedure.


Posted on 4 June 2023 by ScegliAuto

    Frequently Asked Questions

    • Freelander 2006-2016 - Where is the fuel filter of the Land Rover Freelander located? Read Answer
    • Freelander 2006-2016 - Where is the Land Rover Freelander TD4 diesel filter located? Read Answer
    • Freelander 2006-2016 - Where is the Land Rover Freelander 2 diesel filter located? Read Answer
    • Freelander 1997-2006 - Where is the diesel filter on Land Rover Freelander first series? Read Answer
    • Freelander 2006-2016 - Where is the diesel filter on Land Rover Freelander Read Answer
    • Freelander 2006-2016 - Where is the Land Rover Freelander II diesel filter located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos