Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change the Lincoln MKC engine oil and relative filter

Model: Lincoln Mkc MK 1 - Years 2015-2019
Part: Engine oil

The guide shows how to replace the engine oil and relative filter on the Lincoln MKC. The first operation to carry out is to open the cap of the engine oil tank and lift the vehicle. Remove the eight T30 Torx screws holding the motor shield in place. At this point, with a 15 mm wrench, unscrew the oil pan drain bolt and drain the fluid into a suitable disposal container. At this point, unscrew the old oil filter cartridge and drain the remaining oil; check if the filter gasket is still attached to the engine and remove it. Grease the gasket on the new filter and put it back in place. Clean the oil residues and close the protective panel. Once the vehicle has been lowered, top up the tank with the correct amount of engine oil. Turn on the ignition and reset the oil change light from the service menu. Start the engine and run it to circulate the new lubricant.

Posted on 16 June 2022 by ScegliAuto

Video tutorial

Related tutorials

How to replace the air filter in the Lincoln MKC?
How to replace the air filter in the Lincoln MKC?
Lincoln Mkc (2015-2019 / MK 1) In this tutorial, we can see how to replace the air filter in the Lincoln MKC, a very simple and fast operation. Before doing so, make sure the engin…
What is the Lincoln MKC fuse scheme?
What is the Lincoln MKC fuse scheme?
Lincoln Mkc (2015-2019 / MK 1) In this video we can see the diagrams of the fuse boxes, and their respective positions, in the Lincoln MKC, useful in case a device is malfunctionin…
How to reset the service light of the Lincoln MKC
How to reset the service light of the Lincoln MKC
Lincoln Mkc (2015-2019 / MK 1) In the following guide aimed at those of you who own a Lincoln MKC, we will explain step by step how you can perform a manual reset of the service li…

Other guides you may be interested in

Installation of Upgraded Intercooler Radiator with Pipes

Lift the vehicle on suitable axle stands, remove the front wheels, and then the front bumper and grille. Proceed to remove the front headlights; drain the coolant, remove the intercooler radiator and the hoses connecting it to the intake system. Position the new intercooler radiator in the grille, temporarily securing it with cable ties, and mark with a marker the part of the metal that needs to be removed to allow the new hoses to pass through. Cut the marked portion of metal and apply a gasket to the edge. Remove the inner cover of the bumper and position it near the radiator to identify any interfering parts to eliminate: again, apply a gasket to the edge of the cut. Create brackets for securing the new radiator and proceed with the installation of the connecting pipes from the radiator to the intake, shaping and connecting them appropriately. Finally, reassemble the bumper, headlights, and grille.

Watch the video!


by ScegliAuto

More videos