Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Mahindra
  4. :
  5. Maxximo
  6. : How to replace the front bearings of the Mahindra Maxximo

Mahindra Maxximo - Video tutorial

Model: Mahindra Maxximo MK 1 - Years 2010-2015
Part: Checks and maintenance
Operation: How to replace the front bearings of the Mahindra Maxximo

As the video shows, to replace the front bearings of your Mahindra Maxximo you will first have to remove the wheel by unscrewing the bolts and then jacking up the van. Please do not reverse the operations as unscrewing the wheel bolts will become very difficult. Once the bearings are exposed, you can observe the wear and if they actually need to be replaced. Remove both the side retainers and the pin located behind the disc and remove the bearing. At this point you can repair it as shown in the video or replace it with a new one. Reassemble everything.


Posted on 20 September 2022 by ScegliAuto

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos