Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the Bumper and Front Light

Model: Mazda 6 GG, MK 1 - Years: 2002, 2003, 2004, 2005, 2006, 2007, 2008
Part: Headlight

See other generations:
Video tutorial

Open and lift the bonnet, and disconnect the negative connector from the battery to avoid damaging other electrical components. Now remove the two screws located next to the inner tip of the light on the bumper, obviously on both sides.

At this point, you will need to work on the panel located at the bottom of your car. You must remove the panel in front of the wheel and also remove the bolts that secure the bumper from underneath. Now remove the clips that secure the bumper from the inner wing, allowing you to access the bolt that secures the bumper.

You can now pull the bumper off, being careful of the connectors to disconnect. Next, remove the 5 bolts that secure the light to remove it, disconnect the connectors, and perform any necessary maintenance.

You can then follow the steps in reverse for reassembly.


Updated on 23 February 2026 by ScegliAuto


Related tutorials

How to Remove the Rear Bumper on a Mazda 6?
How to Remove the Rear Bumper on a Mazda 6?
Mazda 6 (2008-2012 / MK 2, GH) In this tutorial, you will see how to remove the rear bumper on a Mazda 6, a very simple and quick operation. First, open the boot, then remove the c…
Removing and Replacing the Headlamp
Removing and Replacing the Headlamp
Mazda 6 (2002-2008 / GG, MK 1) The following is a task that can be performed with a few common tools; it is not technically difficult. To remove the headlamp, you need to take off …
Front Bumper Replacement
Front Bumper Replacement
Mazda 6 (2002-2008 / GG, MK 1) To carry out this simple replacement, follow the instructions in this easy and quick guide. Unscrew the screws located under the wing, specifically t…

How to Reset the Tyre Pressure Warning Light on the Jeep Renegade?

To reset the tyre pressure warning light on the Jeep Renegade, inflate the tyres until they reach the recommended pressure: this value is indicated on the sticker attached to the driver’s door pillar. Once the tyres are properly inflated, navigate through the menu that appears on the instrument cluster until you find the tyre pressure option. At this point, press and hold the OK button on the right side of the steering wheel to make the warning light disappear.

Watch the video!


by ScegliAuto

More videos