Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Injector Rail Replacement and Maintenance

Model: Mazda 6 GG, MK 1 - Years: 2002, 2003, 2004, 2005, 2006, 2007, 2008
Part: Fuel injectors

See other generations:
Video tutorial

Open and lift the bonnet, then to protect the electrical components, disconnect the negative cable from the battery. Remove the cover above the engine and start disconnecting the connectors attached to each injector, as well as the larger connector connected to the entire rail pipe; also disconnect it from the clip that holds all the wiring in place, on both sides.

Now you need to remove the pipe that leads fuel into the rail and cap it with the plug located above. Remove the 2 bolts on the rail and gently start to move the rail to extract it. Now you can perform the necessary maintenance and follow the steps in reverse for reassembly.


Updated on 23 February 2026 by ScegliAuto


Related tutorials

Replacing Interior Rear-View Mirror on Mazda 6
Mazda 6 (2002-2008 / GG, MK 1) Replacing the interior mirror on a Mazda 6? Remove the mirror and replace it with a new one. Enter the vehicle, unlock the mirror with a screwdriver …
Replacement and Maintenance of the Control Arm
Replacement and Maintenance of the Control Arm
Mazda 6 (2002-2008 / GG, MK 1) To perform this operation, lift your vehicle to access its underside. If you do not have a ramp, it is sufficient to place your vehicle on axle stand…
How to Reset Scheduled Maintenance on a Mazda 6
How to Reset Scheduled Maintenance on a Mazda 6
Mazda 6 (2012-2024 / GJ, MK 3) This video shows how to reset the scheduled maintenance on a third-generation Mazda 6. First, turn on the instrument cluster without starting the eng…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos