Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mazda
    3. :
  3. Mazda 6
    4. : Injectors

Mazda 6 - Injectors

Mazda 6 (2002-2008 / MK 1, GG)
Rail injector replacement and maintenance
Open and lift the hood, now in order to protect the electrical instruments disconnect the negative cable from the battery. Remove the cover above the engine …read all…
Posted on 21 September 2023 by ScegliAuto
Airbags (2) Alternator (1) Loudspeaker (4) Shock absorbers (5) Air conditioning (1) Car stereo (5) Battery (7) Coil (1) Air Vents (1) Arm (12) Gearbox (1) Spark plugs (7) Bodywork (1) Key (8) Locking the trunk (1) Timing belt (5) V-belt (1) -board computer (1) Checks and maintenance (22) Throttle body (1) Dashboard (3) Bearing (5) Brake discs (5) Headlight (3) Tail light (1) Air filter (1) Cabin air filter (10) Diesel filter (2) Oil filter (1) Grille (3) Injectors (1) Window lift switch (1) Accessory Kit (9) Light bulb (3) Side turn signal light bulb (2) Headlight bulb (8) Interior lights ceiling light bulb (2) Handle (2) Engine (2) Window motor (2) Starter motor (1) Engine oil (6) Door panel (4) Front bumper (3) Rear bumper (3) Brake pads (3) Hydraulic pistons (2) Tires (2) Pump (1) Fuel pump (1) Instrument cluster (3) Radiator (1) Wheel (4) Fuse box (4) Drive shaft (1) Lock (1) Lambda sensor (1) Outside rearview mirror (3) Interior rearview mirror (1) Windscreen wipers (3) Thermostat (3) Engine head (1) Windshield washer nozzle (1) Valve (3) EGR valve (1) Interior blower (1) Steering wheel (2)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos