Do it yourself
Frequently asked questions about cars and motorcycles

Replacing Front Brake Pads

Model: Mercedes Classe C W203 - Years: 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007
Part: Brake pads

See other generations:
Video tutorial

Once the vehicle is lifted and the front wheel is removed, unscrew the caliper mounting bolts and remove the caliper from its seat (pry between the rotor and caliper to slightly retract the piston and facilitate removal); then extract the old pads and shims; apply the new shims (usually included with the new pads) or clean the originals, insert the new pads, retract the caliper piston with a C-clamp, and reattach the caliper, applying the wear sensor.

Pump the brake pedal until it offers the right resistance and pay attention during the first braking.


Updated on 13 February 2026 by ScegliAuto


Related tutorials

Mercedes Classe C (2000-2007 / W203) Lift the vehicle on a hydraulic lift and remove the wheel where the repair will be performed. Unscrew the two mounting pins of the brake caliper loca…
Mercedes Classe C (1983-1993 / ) Brake rotors are a crucial part of vehicle safety and, of course, for the people on board. This component of the vehicle must be replaced immediately…
Mercedes Classe C (2000-2007 / W203) Regularly changing your car's cabin air filter is very important because it protects against external agents that can enter the cabin. It is advisabl…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

Other guides you may be interested in

Where is the battery located on the Aprilia Scarabeo 250ie scooter?

This video shows where the battery is located on the Aprilia Scarabeo 250ie scooter and how to proceed if you need to replace it. As shown, it is located beneath the seat. To access and replace it, first open the seat, then remove the plastic cover by unscrewing the relevant screws with a cross-head screwdriver. Next, disconnect both terminals, starting with the negative, remove the battery from its housing, and install the new replacement following the reverse procedure.

Watch the video!


by ScegliAuto

More videos