|
Do it yourself
| |||
| ||||
Front Brake Pad Replacement
Model: Mercedes Classe C
W203
- Years 2000-2007
Lift the vehicle on a hydraulic lift and remove the wheel where the repair will be performed.
Unscrew the two mounting pins of the brake caliper located at the rear and disconnect the wear sensor connector. Using a medium-sized flathead screwdriver, pry between the rotor and the caliper to slightly retract the caliper piston and create enough clearance to remove the caliper. Then remove the old brake pads and the corresponding retaining springs (new springs are generally included in the package of new pads) and clean the caliper bracket and caliper with appropriate spray. Using a clamp, fully retract the brake caliper piston to accommodate the new pads. Then unscrew the mounting pins of the caliper bracket and the brake rotor mounting pin; remove the rotor (if necessary, tap it with a hammer) and clean the hub; then reinstall the rotor (replace it with a new one if necessary). Reinstall the brake caliper bracket, apply the retaining springs, and insert the new pads reconnecting the sensor connector; then reposition the caliper and tighten the respective mounting pins. Reinstall the wheel and pump the brake pedal until it provides the correct resistance.
Updated on 3 February 2026 by ScegliAuto
Video tutorial
Related tutorials
Mercedes Classe C
(2007-2013 /
W204)
To change the rear brake pads on a Mercedes C-Class, lift the car with a jack on the side where you will perform the replacement. Remove the wheel an…
Mercedes Classe C
(2021-2026 /
W206)
Start by inserting the key into the ignition, turn on the vehicle, and pull up the parking brake lever to disengage it, then turn off the vehicle. No…
Mercedes Classe C
(2000-2007 /
W203)
Lift the car on the lift and remove the rear wheels. Locate the hole on the front of the caliper and use a punch and hammer to drive out the pin that…
Other guides you may be interested in
|
How to Open a Stuck Boot on the Peugeot 407?
On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.102
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |