Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Clk
    4. : Replacement of the anti-roll bar

Mercedes Clk - Video tutorial

Model: Mercedes Clk W208 - Years 1997-2003
Part: Anti roll bar
Operation: Replacement of the anti-roll bar

The central part of the anti-roll bar is connected to the frame and this allows the people occupying the passenger compartment to have greater comfort. When the bar is damaged or worn, it should be replaced. The guide below is intended to give you information on how to change the bar. The car must be positioned on the ramps in order to reduce the load on the fixing points of the bar so that there is no difficulty in removing it. Once this operation has been carried out, the bushings and the relative brackets with which they are fixed must be disassembled. The bar can then be disconnected from the fixing points and removed.


Posted on 14 August 2023 by ScegliAuto



Headlight bulb replacement
Mercedes Clk (1997-2003 / W208) Once the front hood is open, there is enough room to maneuver behind the headlights to be able to proceed with the replacement of the bulbs; start by
Front indicator bulb replacement
Mercedes Clk (1997-2003 / W208) The front indicator light bulb is integrated inside the headlight and replacing it is quite simple but it is still necessary to remove the engine air
Tow hook installation instructions
Mercedes Clk (1997-2003 / W208) The installation of the tow hook is not an operation that can generally be carried out in DIY since, in addition to being approved (in fact the hook

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos