Do it yourself
| ||||
|
Mercedes Classe C - Video tutorial
Model: Mercedes Classe C
W203
- Years 2000-2007 In this tutorial we can see how to disassemble the turn signal switch in the Mercedes C-Class, a very simple operation. First of all, we open the hood, then disconnect the negative terminal of the battery and go inside the passenger compartment. We then locate the hole located on the rear left side of the steering wheel, insert a Torx T30 key and loosen the screw securing the airbag, which will then be removed. At this point, we unscrew the large central bolt with a 10mm hex key, remove the control module and continue by disassembling the turn signal switch. To install the replacement, simply follow the reverse procedure.
Posted on 7 May 2024 by ScegliAuto
Replacement of the light switch for the Mercedes C-Class.
Mercedes Classe C (2007-2013 / W204) .. and replace the light switch of the Mercedes C-Class. First, we get inside the car, on the driver's side, and start removing the plastic side cover..
How to replace the front turn signal bulb of the Mercedes C-Class
Mercedes Classe C (1993-2000 / W202) .. bulb of the front headlight of the Mercedes C-Class. First, we open the hood of the car and begin to disassemble and remove the front headlight; to..
How to remove the light switch of a Mercedes C-Class
Mercedes Classe C (2007-2013 / W204) .. and sit in the driver's seat of our Mercedes C-Class. So let's start by turning the light switch towards "P". Once this is done, we will have to pull.. Other guides that may interest you
|
Frequently Asked QuestionsHow to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.087
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |