|
Do it yourself
| |||
| ||||
Fitting an Additional Chip Tuning Control Unit
Model: Mini Mini
R55, R57, R56
- Years 2007-2014
To improve the performance of the diesel engine, you can install this control unit. You will need to obtain the kit for the specific vehicle. Remove the air filter cover and the related intake pipe. Disconnect the connector from the installed control unit, and after connecting the new additional accessory to the supplied cable, connect one end of this Y-cable to the vehicle's control unit connector and the other end to the connector that was connected to the installed control unit. Essentially, the kit is connected in series with the cable that powers the vehicle's control unit. Position the new control unit in a suitable location and secure it with plastic ties. The kit requires a power supply, so connect the negative wire with a terminal to a screw on the chassis and the positive wire to a switched fuse.
Updated on 3 February 2026 by ScegliAuto
This video is currently unavailable
Related tutorials
Mini
(2010-2016 /
R60, Countryman1)
In the following video, we can observe how to proceed with installing an additional control unit on a Mini diesel engine. This simple operation will …
Mini
(2001-2007 /
R53, R50, R52)
In order to replace the battery of the Mini R50 remote control, you have to pry a flat screwdriver in the lower part of the remote control, that is, …
Mini
(2001-2007 /
R53, R50, R52)
In order to replace the battery of the Mini R50 you need to use an object that acts as a lever to divide the two halves of the remote control cover. …
Other guides you may be interested in
|
How to Remove the Cabin Filter from a Nissan Juke
In this video, let’s see how to remove the cabin air filter from a Nissan Juke. Open the glove compartment and unclip the end stop arms. Then, use a screwdriver to remove the securing screws. After completing the previous steps, unscrew the side screws in the glove compartment and remove the plastic cover. Unscrew the screws again, and after disconnecting the power cables, pull the glove compartment away from the dashboard. Then, slide the air filter out of its housing as shown in the video. Insert the new filter and reassemble all the components of the glove compartment as you disassembled them earlier. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.080
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
