Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Nissan
    3. :
  3. Navara
    4. : Where is the jack located on Nissan Navara NP300

Nissan Navara - Video tutorial

Model: Nissan Navara D23 - Years 2014-2023
Part: Checks and maintenance
Operation: Where is the jack located on Nissan Navara NP300

On the Nissan Navara NP300, the jack (in English called a jack) and all the other tools needed to remove a wheel are located in a compartment under the rear bench seat. To reach them therefore, open the right rear flap and remove the right seat, the one corresponding to the passenger side. Then open the plastic protective cover to access the tool compartment. To extract the jack, rotate the lateral locking pin. Once extracted, inside we will also find a tool bag with the keys necessary to remove the wheel bolts and to use the jack.


Posted on 8 June 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Navara 2014-2023 - Where is the fuel tank of the Nissan Navara located? Read Answer
    • Navara 2014-2023 - What are the problems with the AdBlue of the Nissan Navara? Read Answer
    • Navara 2014-2023 - What are the problems with the AdBlue on the Nissan Navara NP300? Read Answer
    • Navara 2005-2015 - What problems have affected the Nissan Navara? Read Answer
    • Navara 2014-2023 - What are the warning lights on the Nissan Navara? Read Answer
    • Navara 2014-2023 - How much does it cost to replace the courtesy light switches in the Nissan Navarra? Read Answer
    • Navara 2005-2015 - How do I reset the Nissan Navara Service light? Read Answer
    • Navara 2005-2015 - Where is the jack of a Nissan Navara located? Read Answer

How to replace the Ford Transit key battery

Below I will explain how to replace the remote control key battery on the car, take a small screwdriver and pry the rear part of the remote control, (where there is the ring), at which point unhook the back cover and yes will have access to the compartment containing the battery. Always with the help of the small screwdriver, proceed to make the va and lift the battery out of the housing. Then take the new battery (check the type) and place it on the housing, always making sure to position it with the positive pole facing upwards. Finally, close the back cover by re-hooking it to the key.

Watch the video!


by ScegliAuto

More videos