Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Vauxhall
    3. :
  3. Astra
    4. : How to replace the coolant in the Opel Astra?

Vauxhall Astra - Video tutorial

Model: Vauxhall Astra Astra H - Years 2004-2010
Part: Antifreeze liquid
Operation: How to replace the coolant in the Opel Astra?

In this tutorial we can see how to replace the coolant in the Opel Astra, a very simple operation. Before proceeding, we wait for the engine to be completely cold in order to operate safely. We start by removing the cap of the expansion tank, after which we connect a hose to the drain cock, open the valve and let all the liquid contained in the circuit flow out. Then close the tap, pour in the new liquid from the upper hole and let the engine run for a few minutes. We continue by inserting the quantity of liquid necessary to reach the optimal level.


Posted on 22 September 2022 by ScegliAuto



How to replace the coolant temperature sensor of the Opel Astra H.
Vauxhall Astra (2004-2010 / Astra H) The replacement of the coolant temperature sensor on Opel Astra H models is a very simple procedure. Let's start by opening the engine compartment an
Water sensor replacement on Opel Astra
Vauxhall Astra (2009-2016 / Astra J) How do you disassemble the coolant sensor? We disassemble the Opel Astra coolant reservoir. We raise the front hood to access the coolant reservoir.
Replacement of the water temperature sensor of the Opel Astra 1.6 8V
Vauxhall Astra (1998-2006 / Astra G) In this short and simple guide we will see the instructions that will allow us to disassemble and replace the coolant temperature sensor of the Opel

    Frequently Asked Questions

    • Astra 2004-2010 - How much coolant do you need for the Opel Astra? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos