Do it yourself
| ||||
|
Replacement discs and rear pads
Model: Vauxhall Insigna
Insigna A, MK 1
- Years 2008-2017 To replace the rear discs and pads it is advisable to lift the car on the bridge and remove the rear wheel; before proceeding with the disassembly of the brakes, pry between the disc and the pads so as to slightly retract the piston and then unscrew the fixing pins of the caliper and be able to remove it from its seat; remove the old pads and also remove the brake caliper support; at this point unscrew the fixing screw of the disc on the hub, remove the old disc, brush the disc seat on the hub and apply some grease before installing the new one, taking care to clean it from the protective oil; then install the caliper support, insert the sliding plates and the new pads lubricating the edges with copper grease; insert the calliper piston with the special clamp and fix it to the support with the relative pins properly cleaned and lubricated; then pump on the brake pedal until it opposes the right resistance and check the brake fluid level in the reservoir.
Posted on 30 August 2023 by ScegliAuto
How to change the rear brake pads on the Opel Insigna
Vauxhall Insigna (2008-2017 / Insigna A, MK 1) How do you change the rear brake pads of the Insigna? We lift the car with a jack and remove the rear wheel. We unscrew the locking pin of the brake
Replacement of rear brake pads
Vauxhall Insigna (2008-2017 / Insigna A, MK 1) Raise the car on suitable car stands and remove the rear wheel (loosen the pins before lifting); unscrew the fixing pins of the brake caliper and rem
Brake pads replacement
Vauxhall Insigna (2008-2017 / Insigna A, MK 1) Lift the car with a jack and remove the front wheel; unscrew the fixing pins of the brake caliper and remove it; remove the old pads from the support Other guides that may interest you
|
How to deactivate the safe lock on a Volkswagen Golf.The safe lock is indeed an anti-theft system that prevents thieves from accessing the car. This device locks the doors, both externally and internally, when the driver activates the central locking remote control after leaving the vehicle. To permanently disable it, it is necessary to use a diagnostic program such as VCDS that we will connect to the vehicle through the ODBII port. Then wait for the connection and recognition of the control unit and then select the blocks present and locate the safe lock to disable it. And the job will be completed. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.060
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |