Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 207
    4. : Replacement of the thermostat of the Peugeot 207 1.6

Peugeot 207 - Video tutorial

Model: Peugeot 207 MK 1 - Years 2006-2015
Part: Thermostat
Operation: Replacement of the thermostat of the Peugeot 207 1.6

Let's find out in this guide the procedure necessary to remove and replace the thermostat of the Peugeot 207, with 1.6 petrol engine. First we open the engine hood and remove the engine protection cover; then we are going to disassemble the battery, unscrewing the screws of the terminals (positive and negative pole). At this point we disconnect the electrical connector of the thermostat and drain the coolant, disconnecting the pipe from under the radiator; then we unscrew the screws of the thermostat to remove it and replace it with the new one, connecting the various pipes.


Posted on 4 April 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 207 2006-2015 - Where is the coolant thermostat on Peugeot 207? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos