Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 206
    4. : Ignition coil installation instructions

Peugeot 206 - Video tutorial

Model: Peugeot 206 MK 1 - Years 1998-2012
Part: Coil
Operation: Ignition coil installation instructions

The ignition coils of the spark plugs are integrated in a single rectangular plastic block located just behind the engine and fixed with two pins with the 10 mm wrench at both ends; the coil pack also integrates the pipettes of the spark plugs themselves and is connected to the electrical system through a single socket located in a lateral position; to be able to install the new coils it is therefore sufficient to align the pipettes to the spark plugs and press the block downwards until the contacts of the pipettes fit perfectly into the spark plugs; once in place, tighten the two fixing pins and connect the socket.


Posted on 28 August 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 206 1998-2012 - Where are the ignition coils of the Peugeot 206 located? Read Answer
    • 206 1998-2012 - Where are the coils of the Peugeot 206 located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos