Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. Partner Tepee
    4. : Replacement of the clutch cable for the Peugeot Partner Tepee 2.0 HDI.

Peugeot Partner Tepee - Video tutorial

Model: Peugeot Partner Tepee MK 1 - Years 1996-2013
Operation: Replacement of the clutch cable for the Peugeot Partner Tepee 2.0 HDI.

Today we will show you the main steps that will allow us to disassemble and replace the clutch cable of the Peugeot Partner Tepee 2.0 HDI. First, we lift the vehicle and start by disconnecting the clutch cable from the bracket located on the gearbox; then we unscrew the adjusting screw to remove it, disconnecting it from the clutch pedal, as shown in the video. At this point, we properly attach the clutch cable to the gearbox, passing it through its sleeve; finally, we perform the adjustment, following the video tutorial until the end!


Posted on 11 November 2023 by ScegliAuto

    Frequently Asked Questions

    • Partner Tepee 2008-2018 - What to do when the Peugeot Partner's horn no longer works? Read Answer
    • Partner Tepee 2008-2018 - Where is the horn relay located on the Peugeot Partner? Read Answer
    • Partner Tepee 2008-2018 - What does the orange triangular warning light mean on the Peugeot Partner? Read Answer
    • Partner Tepee 2008-2018 - What is the position of the horn on the Peugeot Partner? Read Answer
    • Partner Tepee 2008-2018 - Where is the jack on a Peugeot Partner? Read Answer
    • Partner Tepee 2008-2018 - Where is the jack of a Peugeot Partner located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos