Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. Partner Tepee
    4. : Where is the heating resistor located in the Peugeot Partner van?

Peugeot Partner Tepee - Video tutorial

Model: Peugeot Partner Tepee B9 - Years 2008-2018
Part: Checks and maintenance
Operation: Where is the heating resistor located in the Peugeot Partner van?

In this video, we can see where the heating resistor is located in the Peugeot Partner van and how to proceed in case we need to replace it, which is a very simple operation. As shown, the resistor in question is positioned inside the passenger compartment on the driver's side, just below the dashboard. Before proceeding, make sure the key is not inserted, then remove the lower protective panel and disconnect the indicated connector. Next, unscrew the single fixing bolt with a 5.5mm wrench, remove the resistor, and install the replacement.


Posted on 24 November 2023 by ScegliAuto

    Frequently Asked Questions

    • Partner Tepee 2008-2018 - How to reset the engine error light on Peugeot Partner? Read Answer
    • Partner Tepee 2008-2018 - What does the yellow triangle warning light with an exclamation point on the Peugeot Partner indicate? Read Answer
    • Partner Tepee 2008-2018 - What does the orange triangle-shaped warning light with an exclamation mark mean on the Peugeot Partner? Read Answer
    • Partner Tepee 2008-2018 - What does the engine fault light on the Peugeot Partner mean? Read Answer
    • Partner Tepee 2008-2018 - What does the triangle light on the Peugeot Partner mean? Read Answer
    • Partner Tepee 2008-2018 - Where is the engine starter fuse located in the Peugeot Partner? Read Answer
    • Partner Tepee 2008-2018 - Where is the Peugeot Partner jack located? Read Answer
    • Partner Tepee 2008-2018 - What does the TPMS warning light mean on a Peugeot Partner? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos