|
Do it yourself
| |||
| ||||
How to Replace the Diesel Filter on Renault Megane 1.5 DCI?
Model: Renault Megane
Megane 2
- Years 2002-2010
To change the diesel filter on a Renault Megane, first open the bonnet and remove the engine cover. Then, as explained in the video, lift the front of the car with a jack and remove the front right wheel; otherwise, access to the filter is impossible. Also, remove the wheel arch liner as the filter is located behind it. At this point, you can disconnect the fuel inlet and outlet pipes from the diesel filter and remove the pressure pump pipe. Once done, lift the diesel filter slightly to extract it from its position, remembering to place a container underneath to protect the ground from any spilling liquids. Then, disconnect the pipes by pressing on the coloured part of the connector, as indicated in the video, while pulling the pipe simultaneously. Repeat the same for the other pipes. Now you can install the new filter, removing the caps covering the pipes first, and perform the procedures in reverse order to reassemble.
Updated on 25 April 2026 by ScegliAuto
Video tutorial
Related tutorials
Renault Megane
(2015-2023 /
Megane 4, Megane IV)
Replacing the diesel filter on a Renault Megane? Here’s how to do it. Lift the car on a column lift, and remove the protection panel. Locate the dies…
Renault Megane
(2015-2023 /
Megane 4, Megane IV)
This guide shows how to locate and replace the diesel filter on the Renault Megane Mk4. The filter is located at the front of the left rear wheel. To…
Renault Megane
(2008-2015 /
Megane III, Megane 3)
Do you want to replace the diesel filter on this vehicle? The diesel filter is located behind the right front headlamp. To replace it, you need to re…
Other guides you may be interested in
|
How to reset the tyre pressure warning light on the Suzuki Jimny?
To reset the tyre pressure warning light on the Suzuki Jimny, first inflate the tyres to the pressure value indicated on the corresponding sticker: this is located at the bottom of the driver's door pillar. Once the tyres are inflated, insert the ignition key and turn on the instrument panel: select the screen that indicates the tyre pressures, checking that the values change. After a few seconds, the tyre pressure warning light will automatically turn off. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.070
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |