Do it yourself
Frequently asked questions about cars and motorcycles

How to Reset the Service Light on Renault Clio 1.5 dCi

Model: Renault Clio Clio IV, MK 4, Clio 4 - Years 2012-2019
Part: Service warning light

To reset the oil change service indicator on the Renault Clio dCi, proceed as follows: open the door and access the driver's seat, insert the ignition key and switch on the ignition (do not start the engine). On the right side of the steering wheel, there is a multifunction lever with two controls at the end labelled "arrow up" and "arrow down". Press the "arrow up" control and scroll through the menu until you reach "service interval". At this point, hold the "arrow up" control for a few seconds until the indicator starts to flash, then press and hold the same button again for a few seconds. This will update the service indicator.

Updated on 14 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Renault Clio (2019-2026 / Clio V, Clio 5) Let's discover the instructions that will allow us to reset the AdBlue refill warning for the Renault Clio 1.5 dCi. First of all, it is necessary to …
Renault Clio (2012-2019 / Clio IV, MK 4, Clio 4) Below we will discover the information that will illustrate the procedure for dismantling and replacing the timing belt of the Renault Clio 1.5 dCi. …
Renault Clio (2012-2019 / Clio IV, MK 4, Clio 4) Today’s main instructions will show you how to remove and replace the clutch on the Renault Clio 1.5 dCi. First, raise the vehicle and start by remov…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos