Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Start the Smart with Automatic Gearbox

Model: Smart Smart 451 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015

See other generations:
Video tutorial

In this video, you will learn how to start the Smart with an automatic gearbox. Once inside the cabin, you will notice that there are only two pedals: the one on the right is the accelerator and the one on the left is the brake.

Obviously, there is no clutch. Looking at the centre, between the two seats, you will find the automatic gear lever and the ignition key slot.

Ensure that the automatic gear lever is in the neutral position. At this point, turn the key slightly to the right and the engine will start.

With the brake pressed, push the gear lever to the left into position A (automatic). You can now drive away.


Updated on 1 June 2026 by ScegliAuto


Related tutorials

How to reset the automatic gearbox on the Smart?
How to reset the automatic gearbox on the Smart?
Smart (2007-2015 / 451) To reset the automatic gearbox on the Smart, connect a diagnostic tool to the vehicle's OBD port: this port is located on the lower part of the dashb…
How to Drive a Smart with Automatic Gearbox
How to Drive a Smart with Automatic Gearbox
Smart (2014-2022 / 453) In this video, learn how to drive a Smart with a dual-clutch automatic gearbox: if the old robotic gearbox was the weak point of the previous Smart, …
How to Start a Smart with a Flat Battery
How to Start a Smart with a Flat Battery
Smart (1998-2007 / 450) If the battery is flat to the point that it does not allow the starter motor to turn over, even if the vehicle has an automatic gearbox, it is possib…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos