Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Toyota
    3. :
  3. Avensis
    4. : Rear light bulb

Toyota Avensis - Rear light bulb

Toyota Avensis (2009-2018 / MK 3, T270)
How do you replace the rear headlight bulb of the Toyota Avensis?
In order to replace the rear headlight bulb of the Toyota Avensis, you need to open the rear hatch so that you can access the components inside the trunk: here …read all…
Posted on 9 May 2024 by ScegliAuto
Toyota Avensis (2003-2008 / T250, MK 2)
Replacement of the rear lights of the Toyota Avensis
Below we will see the necessary instructions on how to disassemble and replace the rear headlight bulbs of the Toyota Avensis, in simple and quick steps. …read all…
Posted on 9 January 2024 by ScegliAuto
Toyota Avensis (2003-2008 / T250, MK 2)
How to replace the rear light bulb on Toyota Avensis
Replacing the rear light bulbs on Toyota Avensis is quite simple as these are easily accessible by removing the light. Inside the boot, in correspondence with …read all…
Posted on 20 November 2023 by ScegliAuto
Alternator (5) Car stereo (2) Battery (3) Coil (1) Spark plugs (2) Glow plugs (1) Bodywork (1) Control unit (1) Key (1) Timing belt (4) V-belt (2) -board computer (1) Checks and maintenance (29) Dashboard (1) Bearing (1) Brake discs (1) Air filter (3) Cabin air filter (6) Diesel filter (3) Side turn signal light bulb (1) Headlight bulb (7) Rear light bulb (3) Interior lights ceiling light bulb (1) License plate light (1) Engine (3) Starter motor (2) Engine oil (3) Door panel (1) Brake pads (3) Gear Shift Knob (2) Fuel pump (2) Push button (1) Instrument cluster (6) Wheel (1) Fuse box (10) Outside rearview mirror (1) Windscreen wipers (2) EGR valve (2) Steering wheel (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos