Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Toyota
    3. :
  3. Avensis
    4. : Engine

Toyota Avensis - Engine

Toyota Avensis (2003-2008 / T250, MK 2)
Intake manifold gasket replacement
If you have to replace the intake manifold gasket, the first phase is certainly cleaning: it is in fact necessary to eliminate any residual dirt and …read all…
Posted on 9 August 2023 by ScegliAuto
Toyota Avensis (2003-2008 / T250, MK 2)
Replacement of the oil seal ring
In this video tutorial a new oil seal ring is installed on a Toyota Avensis. The aforementioned ring is contained in a completely new package of components, …read all…
Posted on 9 August 2023 by ScegliAuto
Toyota Avensis (2003-2008 / T250, MK 2)
Replacing the tappet cover gasket
Before applying the new gasket, carefully clean the relative seat both on the cylinder head side and on the tappet cover side in order to eliminate any …read all…
Posted on 6 August 2023 by ScegliAuto
Alternator (5) Car stereo (2) Battery (3) Coil (1) Spark plugs (2) Glow plugs (1) Bodywork (1) Control unit (1) Key (1) Timing belt (4) V-belt (2) -board computer (1) Checks and maintenance (29) Dashboard (1) Bearing (1) Brake discs (1) Air filter (3) Cabin air filter (6) Diesel filter (3) Side turn signal light bulb (1) Headlight bulb (7) Rear light bulb (3) Interior lights ceiling light bulb (1) License plate light (1) Engine (3) Starter motor (2) Engine oil (3) Door panel (1) Brake pads (3) Gear Shift Knob (2) Fuel pump (2) Push button (1) Instrument cluster (6) Wheel (1) Fuse box (10) Outside rearview mirror (1) Windscreen wipers (2) EGR valve (2) Steering wheel (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos