Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Toyota
    3. :
  3. Yaris
    4. : Replacing the spark plugs on the Yaris

Toyota Yaris - Video tutorial

Model: Toyota Yaris Xp90 - Years 2005-2011
Part: Spark plugs
Operation: Replacing the spark plugs on the Yaris

Replacing spark plugs on a Toyota Yaris? Let's see how they disassemble the engine from inside. We pull the lever to open the engine compartment located at the bottom left of the dashboard and lift the front hood, we secure the same. Remove the motor cover panel, unscrew the locking pins of the coils with a special socket wrench, then disconnect the electrical terminal. We grab the coil with our hands and rotate it in a twist way, until it is extracted from the head. Unscrew the spark plugs with a socket wrench (extract them from the head). We mount the new spark plug in the cylinder head with the socket wrench. Finally we reassemble the engine cover panel and test the operation of the engine.


Posted on 20 December 2023 by ScegliAuto



Toyota Yaris spark plug replacement
Toyota Yaris (2005-2011 / Xp90) Today we will see, in this video tutorial, how to remove and replace the Toyota Yaris engine spark plugs, following these simple and quick steps. Fir
Removing the spark plugs on Toyota Yaris
Toyota Yaris (2005-2011 / Xp90) How to remove the Toyota Yaris spark plugs? Let's see how the Toyota Yaris spark plugs are removed. We raise the front hood, we secure the same. We r
How to replace the spark plugs in a Toyota Yaris.
Toyota Yaris (2005-2011 / Xp90) In today's video, we will see how to replace the spark plugs in the Toyota Yaris gasoline engine. We recommend proceeding with a cold engine to avoid

Other guides that may interest you

    Frequently Asked Questions

    • Yaris 2011-2019 - Toyota Yaris 1000 spark plugs cost? Read Answer

How do you reset the tire pressure warning light on Hyundai I10?

In order to reset the tire pressure warning light on the Hyundai I10 there is no procedure that can be carried out independently. First of all, the flat tires must be returned to the correct inflation pressure, indicated on the sticker stuck in the driver's door pillar. Once the tire in question has been inflated, a diagnostic tool can be connected to the vehicle's OBD port so that the error can be reset. By following the procedure indicated in the tutorial, it will be possible to reset the warning light and turn on the ignition to check that everything has been done correctly.

Watch the video!


by ScegliAuto

More videos