Do it yourself
Frequently asked questions about cars and motorcycles

Checking and Topping Up Fluid Levels on Toyota Aygo 1.4 D Version 1

Model: Toyota Aygo Ab10, MK 1 - Years: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014
Part: Checks and maintenance

See other generations:
Video tutorial

In this video, see how to check and top up the fluid levels of the Toyota Aygo 1.4 diesel version 1. You will need containers of engine oil, brake fluid, antifreeze, and windscreen washer fluid. It is preferable to get small containers that can be kept in the boot.

The antifreeze is yellow, while the engine oil is a synthetic SAE 5W30. Check the levels with the engine off and the car on the ground. First, extract the oil dipstick, wipe it clean, replace it, and pull it out again; it should never exceed the maximum.

It must be between min. and max. If the level is low, open the filler cap and add some oil. For the coolant, open the expansion tank cap and fill it to the maximum level (not more). The brake fluid reservoir has a min. and max. indicator.

When it drops, it means the pads are worn. Again, if the level is below maximum, add fluid, but do not underestimate what this indicator tells you! Add some fluid to the washer reservoir so that the sprayer can always do its job. Operation complete.


Updated on 26 September 2026 by ScegliAuto


Related tutorials

Toyota Aygo (2014-2023 / Ab40, MK 2) In today's video, we will see how to turn off the tyre pressure monitoring system warning light in the second generation Toyota Aygo. This tutorial a…
Toyota Aygo (2021-2026 / MK 3, Aygo X) In this video, we see how to change the time on a Toyota Aygo Cross X: the system may vary slightly depending on the trim level and infotainment syst…
Toyota Aygo (2005-2014 / Ab10, MK 1) The standard speakers in the Toyota Aygo are not of great quality: simply raising the volume above level 20 causes them to crackle, so it is advisabl…

Other guides you may be interested in

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos