Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the AdBlue Warning Light with VCDS?

Model: (Various brands) Various
Part: AdBlue warning light

To reset the AdBlue warning light on a vehicle using VCDS, first connect it to the vehicle's OBD port to communicate with the control unit. The OBD port is generally located on the lower left side of the dashboard, near the steering column. Once the scanner is connected, select the car model in question and its corresponding version, then follow all the other instructions shown in the tutorial. At the end of the procedure, you can disconnect the scanner and check that the warning light has been reset.

Updated on 16 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the AdBlue Warning Light with the VCDS System
How to Reset the AdBlue Warning Light with the VCDS System
(Various brands) Various To reset the AdBlue warning light using the VCDS diagnostic system, follow the instructions below and refer to the video. First, connect your PC to t…
How to Reset the AdBlue Warning Light
How to Reset the AdBlue Warning Light
(Various brands) Various To reset the AdBlue warning light when it is flashing, accompanied by an audible signal and a message indicating that the remaining driving range is …
What to Do When the AdBlue Warning Light Comes On?
What to Do When the AdBlue Warning Light Comes On?
(Various brands) Various What to do when the AdBlue warning light comes on? When the AdBlue light illuminates and starts flashing, it means that the fluid in the designated r…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos