|
Do it yourself
| |||
| ||||
Removing Door Panel for Replacement
Model: Volkswagen Passat
3BG, B5
- Years:
1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
Video tutorial
The tools required for this operation are: a flathead screwdriver, a Phillips screwdriver, a T25 Torx key, and a spatula. Remove the handle cover and unscrew the retaining screws. Also unscrew all the screws from the panel and, using the spatula, gently remove the panel along the edges, which should be carefully pulled upwards. Disconnect the electrical contacts by unplugging the connectors, taking care not to pull them. Refit the new panel, starting with the connection of the electrical cables. Position the panel upwards and then push it down until it clicks into place. Reinsert the screws.
Updated on 2 February 2026 by ScegliAuto
Related tutorials
Volkswagen Passat
(1996-2005 /
3BG, B5)
Remove the door panel from a VW Passat? Start by removing the protection panel above the door and all its components. Use a trim tool to remove the p…
Volkswagen Passat
(2005-2010 /
B6, 3C)
Removing the inner door panel to access the lock? Here’s how to remove the panel from the Passat. Detach the cover under the handle and unscrew the s…
Volkswagen Passat
(1996-2005 /
3BG, B5)
Learn how to remove the speaker from inside the door of the Passat. Open the door and start disassembling the cover panel. Remove the handle cover: u…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.
Other guides you may be interested in
|
How to adjust the headlights in the Toyota RAV4?
In this tutorial, you can see how to adjust the headlights in the Toyota RAV4, a very simple and quick operation. First, position the vehicle in front of a wall, about 40 centimetres away, then switch on the headlights and open the bonnet. Next, locate the small hole on both headlamps, apply tape on the wall at the same height, and using the indicated adjustment ring, position the beam of light so that it is perpendicular to the tape. Finally, move the vehicle back and check that the beam falls below the tape; if not, lower it slightly. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.081
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy - About us VAT number: IT01247470535 |