Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of Turbo Pressure Vacuum Gauge

Model: Volvo V70 MK 2 - Years 2000-2007
Part: Accessory kit

Start by connecting the tubing to the back of the vacuum gauge and the power cable; then install the vacuum gauge into the bracket, which will allow for subsequent installation on the dashboard. Position the device in the lower left part of the dashboard and route the tubing through the various grommets until it reaches the engine bay; then apply a "T" fitting to the end of the tubing and connect it to the pipe located under the intake manifold, creating a bypass. Next, connect the power with one terminal to ground and the other to positive (connect to the cigarette lighter).
Secure the device to the dashboard using double-sided tape.

Updated on 7 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Installation of Detachable Towbar
Installation of Detachable Towbar
Volvo V70 (2000-2007 / MK 2) Open the rear bonnet, lift the cover panel, remove the spare wheel, and take off the trims to access the fastening pins of the rear bumper for remova…
How to Reset the Tyre Warning Light on the Volvo V70
How to Reset the Tyre Warning Light on the Volvo V70
Volvo V70 (2007-2016 / MK 3) To reset the tyre warning light on your Volvo V70 third generation (2007-2016), follow the steps in this guide. First, enter the cabin and switch on …
How do you reset the tire pressure light on the Volvo V70?
How do you reset the tire pressure light on the Volvo V70?
Volvo V70 (2007-2016 / MK 3) In order to reset the tire pressure warning light on the Volvo V70, you need to turn on the instrument panel without starting the vehicle. Then, you …

Other guides you may be interested in

How to Open the Bonnet of a Renault Megane if the Lever is Broken?

If the lever that unlocks the bonnet of the Renault Megane is broken or not functioning, there is an emergency procedure to unlock the mechanism: remove the right front grille located at the top of the bumper. Once the grille is removed, you can locate the actuator mechanism: by pulling the spring in this position, you can unlock the actuator, allowing you to lift the bonnet and access the components located inside the engine compartment. You can then close the bonnet simply by lowering it.

Watch the video!


by ScegliAuto

More videos