Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Service Light on the Volvo V40?

Model: Volvo V40 MK 2 - Years 2012-2019
Part: Service warning light

On the Volvo V40, the procedure to reset the Service light involves turning on the ignition by rotating the key, then pressing and holding the OK button located at the end of the lever to the left of the steering wheel. This will cause a red warning light to start flashing, and when it disappears completely, you can turn off the instrument cluster. At this point, turn it back on, confirming that the Service light has disappeared from the instrument cluster; at the end of the procedure, the instrument cluster can be turned off.

Updated on 11 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to reset the Service light on the Volvo V40?
How to reset the Service light on the Volvo V40?
Volvo V40 (2012-2019 / MK 2) To reset the Service light on the Volvo V40, turn the ignition on by rotating the key. Then, press and hold the OK button located at the end of the l…
How to Reset the Service Light on the Volvo V40?
How to Reset the Service Light on the Volvo V40?
Volvo V40 (2012-2019 / MK 2) To reset the Service light on the Volvo V40, turn on the instrument panel by rotating the key in the ignition switch, then press and hold the OK butt…
How to Reset the Service Light on a Volvo V40?
How to Reset the Service Light on a Volvo V40?
Volvo V40 (2012-2019 / MK 2) To reset the Service light on a Volvo V40, turn the ignition key to switch on the instrument panel. Then, press and hold the OK button located at the…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos